Setup; Getting Started; What You Need; Putting It All Together - Micron ClientPro XVI User Manual

Getting Started

Before your new system left the factory, Micron configured the hardware. The display
adapter was set to work with your monitor and the hard disk was partitioned and formatted
with DOS using the standard default settings for your machine. Your computer system
is ready to go. All you have to do is plug it in.

What You Need

♦ A grounded power outlet
♦ Phillips-head screwdriver
♦ Power filter/suppressor protector (recommended)

Putting It All Together

To complete your setup refer to the following steps:
1. Take a moment and review the case figures on the following pages to
acquaint yourself with the front and back of your system.
2. Check the voltage selector on the rear of the unit. Be sure it is switched for
the proper voltage (115V in the United States and Canada).
3. Place the monitor where you wish, as long as its cable can still
reach the video connector at the rear of the computer.
4. Unpack the power cable for the computer and plug the appropriate end into
the power inlet at the back of the system. Insert the other end into a grounded
power outlet. We highly recommend that you obtain a protection device such
as an uninterruptable power supply (UPS), power filter or surge suppressor. In
this way you will be providing the utmost protection for your system and data.
5. Ensure that the system is turned OFF before proceeding. Attaching
peripherals while the power is on may damage the unit or the peripheral.
6. Locate the monitor's power cable and plug the appropriate end into the
monitor (if not already attached). Insert the other end into the grounded outlet
or protection device.
Micron Electronics, Inc.
Chapter 1: Setting Up Your System

Setup

1-3