Simm Modules - Micron ClientPro XVI User Manual

The memory in this system can be increased up to a maximum of 128MB by installing
SIMMs (single in-line memory modules). To install SIMMs, first locate the memory banks
on the system board (refer to Figure 2-1). Follow figure 2-12 on page 2-15 for the possible
installation combinations.
CAUTION:
Even a small electrostatic discharge could damage the module. A
damaged module might not fail immediately, but over time it will
become worse, possibly causing an "intermittent" problem. Be
very careful to handle the boards ONLY by the edges. DO NOT
touch the gold/silver edge-connectors or any of the components
on the board. Leave the module in the antistatic bag until ready for
installation.
1. Switch the computer off. Leave the computer plugged in to the
outlet to provide an electrical ground to discharge static electricity.
2. Touch the metal case of the power supply or the
metal lining inside the computer case. This will drain the static
charge from your body and will keep the modules from
being electrically damaged.
3. Keep body movement to a minimum as you remove and handle the
modules. Antistatic wrist straps with clip-on ends are commercially
available.
Micron Electronics, Inc.
Chapter 2: Technical Information

SIMM Modules

Modules are Electrostatic Sensitive.
2-11