Introduction; Problems During Boot - Micron ClientPro 766Xi System User's Manual

Micron ClientPro 766Xi/Xe User's Guide

Introduction

Occasionally while setting up and configuring a computer system, an error
may occur or an important element may be forgotten. This section provides
information regarding the most frequently encountered problems, as well as
many quick and simple solutions. If you continue to experience problems and
this section fails to provide solutions, please feel free to contact Micron technical
support (see Appendix A: Contacting Technical Support).

Problems During Boot

Problem
When the power switch is turned on, the system does not power up
(i.e., the exhaust fan does not run, the power indicator light is not
illuminated, the hard disk does not begin to spin, etc.), and no audible
"beep" is heard.
Possible Cause
The power cable is unplugged or defective.
Voltage switch is improperly set.
No power at outlet.
Bad power supply.
Solution Checklist
Check to ensure the power cable is plugged in correctly and
firmly. Try a second power cable, if available, or test the cable
for continuity. Replace original cable if it is found to be defective.
Check the red voltage switch (located at the rear of the unit near
the fan) and ensure that it is set for the proper voltage (115V in
the U.S. and Canada).
Check the outlet with another appliance (e.g., a lamp).
If a surge suppressor or Uninterruptable Power Supply (UPS) is
being used, temporarily bypass the surge suppressor and plug
the unit directly into the wall outlet. The surge suppressor or
UPS may be faulty.
4-2 Micron Electronics, Inc.