Micron ClientPro XVI User Manual page 47

Number of Sectors
If Hard Disk Type is set to User Definable, you must type the correct number of
sectors for your hard disk. If Hard Disk Type is set to Auto Configured, this
reports the number of sectors for your hard disk and cannot be modified.
Maximum Capacity
Reports the maximum capacity of your hard disk. It is calculated from the
number of cylinders, heads, and sectors. There are no options here.
IDE Translation Mode
Specifies the IDE translation mode. The options are Standard CHS (standard
cylinder head sector (less than 1024 cylinders), Logical Block, Extended CHS
(extended cylinder head sector(greater than 1024 cylinders), and Auto Detected
(BIOS detects IDE drive support for LBA).
Do not change this from the option selected when the
hard drive was formatted. Changing the option can
result in corrupted data.
Multiple Sector Setting
Sets the number of sectors transferred by an IDE drive per interrupt generated.
The options are Disabled, 4 Sectors/Block, 8 Sectors/Block, or Auto Detected.
The default is Auto Detected. Check the specifications for your hard disk drive
to determine which setting provides optimum performance for your drive.
Fast Programmed I/O Modes
Sets how fast transfers on the IDE interface occur. The options are Disabled or
Auto Detected. The default is Auto Detected. If set to Disabled, transfers occur
at a less than Standard Compatable Mode.
3-8
Micron ClientPro X
CAUTION
User's Guide
VI
Micron Electronics, Inc.