Mini Tower Case - Micron ClientPro XVI User Manual

Chapter 1: Setting Up Your System

Mini Tower Case

Refer to the figures below. No tools are required. It is not necessary to disconnect the
cable connectors on the back of the computer before opening the cover. However, note
where the cables connect to the back for future reference . (If you have a video camera,
a quick scan of the rear case is helpful).Lay the computer on it's right side by rotating
it clockwise 90 degrees.
1. Remove the thumb screw located in the top rear center of the lid. While standing in
front of the computer, use your right thumb to press in on the right rear release tab. At the
same, time place your left hand on the right rear corner of the lid. Push down and rearward
about ¾ of an inch, AS SHOWN ABOVE.
2. Next, use your left thumb to press in on the left rear release tab. At the same time,
place your right hand on the left rear corner of the lid. Push down and rearward, about
¾ of an inch, AS SHOWN ABOVE.
3. Grasp the two rear corners of the lid and lift it straight up.
To replace the cover, gently lower the top latching hooks into the top chassis channels
before pushing the rear of the cover into place. When the cover is pushed forward the
flexiable release tabs will lock into place and the thumb screw can be fully tightened.
Micron Electronics, Inc. 1-15