Micron ClientPro XVI User Manual page 49

Num Lock
Sets the beginning state of the Num Lock feature on your keyboard. The
options are On and Off.
Speaker
Turns the on-board speaker control to on or off. The options are Enabled and
Disable.
Setup Prompt
Turns on (or off) the "Press <F1> Key if you want to run Setup" prompt during
the power-up sequence. The options are Enabled and Disabled.
This option has no effect on your ability to access the
Setup program. It only toggles the prompt.
Hard Disk Pre-delay
Sets the hard disk drive pre-delay. The options are Disabled, 3, 6, 9, 12, 15, 21,
or 30 seconds. The default is 3 seconds. When enabled, this option causes the
BIOS to wait the specified time before it accesses the first hard drive. If your
system contains a hard drive, and you don't see the drive type displayed during
boot-up, the hard drive may need more time before it is able to communicate
with the controller. Setting a pre-delay provides additional time for the hard drive
to initialize.
Typematic Rate Programming
Sets the typematic rates. The options are Default and Override. Choosing
Override enables Typematic Rate Delay and Typematic Rate.
Typematic Rate Delay
Sets how long it takes for the key-repeat function to start when you hold
down a key on the keyboard. The options are 250, 500, 750, and 1000
millisecond delays. The default is 250. If Typematic Rate Programming is
set to Default, this option will not be visible.
Typematic Rate
Sets the speed at which characters repeat when you hold down a key on the
keyboard. The higher the number, the faster the characters repeat. The
options are 6, 8, 10, 12, 15, 20, 24, and 30 characters per second. The
default is 6. If Typematic Rate Programming is set to Default, this option will
not be visible.
Scan User Flash Area
This selection allows scanning of User Flash Area for option ROMs. The
options are Disable or Enable.
3-10
Micron ClientPro X
NOTE
User's Guide
VI
Micron Electronics, Inc.