Exiting/Saving The Cmos Selections - Micron ClientPro XVI User Manual

Micron ClientPro X User's Guide
VI

Exiting/Saving the CMOS Selections

After you have completed configuring the BIOS, select the Exit Screen (Figure 3-12),
and choose one of the following options.
Figure 3-12. Exit Screen
Exit Saving Changes
Saves the changes to CMOS RAM and exits the Setup program. You can also press
the <F10> key anywhere in the Setup program to do this.
Exit Discarding Changes
Exits the Setup program without saving any changes. This means that any changes
made while in the Setup program are discarded and NOT SAVED. Pressing the
<Esc> key in any of the four main screens will do this.
Load Setup Defaults
Resets all of the setup options to their defaults. You can also press the <F5> key
anywhere in the Setup program to do this. This selection loads the default Setup
values from the ROM table.
Discard Changes
Discards any changes you made during the current Setup session without exiting the
program. You can also press the <F6> key anywhere in the Setup program to do
this. This selection loads the CMOS RAM values that were present when the system
was turned on.
3-24 Micron Electronics, Inc.