Advertisement
INSTALLATION INSTRUCTIONS
Ensign 40-2 Counter Type Dishwasher
Machine Specifications
Insinger model Ensign 40_2 stainless steel counter
type dishwasher with automatic timing of the wash and
rinse cycle with either electric immersion heater for
tank heat and electric heat exchange booster for rinse
or steam coils for tank heat and steam heat exchange
booster for rinse.
ELECTRICAL REQUIREMENTS
(specified by end-user):
1/2 HP, 110-120/240 single phase or 208-220/460VAC
three phase, 60 cycle. Motor operates through a timed
cycle controller. Rinse operates through a 24VAC
solenoid valve actuated by the timed cycle controller.
Feed:
Side door loading, counter top installation. Direction
of feed specified by end-user.
Tools:
No special tools required for cleaning or maintenance.
Cleanout brush provided for the spray pipes. Machine
must be welded into the tabletop (unless provided with
a stand).
Dishbaskets:
16" square plastic inserts.
Placement
Carefully uncrate machine. Take caution not to
damage components which may be mounted on the
top or sides of the machine. Set unit in the table cut-
out. Refer to installation drawing in this section for
table cut-out dimensions. Weld the dish machine into
the table. Install temp gauges.
Electrical Connections
Connect electrical lines sized for the correct voltage,
current and phase of the machine. These should
agree with the machine requirements indicated on the
nameplate and labels on the control panel. A single-
point electrical connection is provided for the pumps,
control circuit, and wash tank heater. If an electric
booster is provided, connect power directly to the
booster.
Ensign_40-2_TM2009
®
7
PART 2 INSTALLATION INSTRUCTIONS
CAUTION:
Connections must be made to a circuit breaker
or fused disconnect as provided by the end-user
and required by local codes.
A laminated wiring diagram is inside the control panel.
Chemicals
Upon the completed installation of the dishwasher,
contact a local detergent/chemical supplier for the
correct chemicals for your soil load and geographical
area.
Electrical connection points for the detergent
dispenser and rinse injector are located inside the
control panel. Refer to the wiring diagram for this
machine for the proper connection points.
Dispensers may be connected on either the primary
voltage side of the machine or the 24VAC control
CAUTION:
When connecting on the 24VAC control voltage side of
the transformer, total VA must not exceed 50VA.
Tabling
Load and unload tables should be pitched towards
the machine to return excess water into the machine.
www.insingermachine.com
800-344-4802
Advertisement
