Stopping The Engine - Kipor Sinamaster I G2600 Operation Manual

Output and Overload Indicators
The output indicator light(green) will remain ON during normal operating
conditions.
If the generator is overloaded(in excess of 2.6kVA), or if there is a short in the
connected appliance, the output indicator light(greer) will go OFF, the overload
indicator light(red) will go ON and current to the connected appliance will be shut
off.
Stop the engine if the overload indicator light (red) comes ON and investigate the
overload source.
If the oil level indicator light comes on, please check it.
NOTE
Before connecting an appliance to the generator, check that it is in good order,
and that its electrical rating doe not exceed that of the generator. Then connect
the power cord of the appliance, and start the engine.
NOTE
When an electric motor is started, both the overload indicator light(red) and the
output indicator light (green) may go on simultaneously. This is normal if the
over-load indicator light(red) goes off after about four (4) seconds. If the overload
indicator light (red) stays on, consult our generator dealer.
Output Indicator Light (Green)
Overload Indicator Light (Red)

7.STOPPING THE ENGINE

To stop the engine in an emergency, turn the engine switch to the OFF position.
IN NORMAL USE:
1.Switch off the connected equipment and pull the inserted plug.
2.Turn the engine switch to the OFF position.
Engine Switch
Plug
ON
OFF
ON