Installing The Battery Pack - Intermec Trakker Antares 243X User Manual

Chapter 1— Learning About the Terminal

Installing the Battery Pack

10
nugget
Contact your local Intermec sales representative for a replacement battery
pack. DISPOSE OF USED BATTERY PACKS PROMPTLY. KEEP
THEM AWAY FROM CHILDREN.
Note: Do not press f or ' when there is no battery pack installed in
the terminal.
To install the battery pack
1 The 243X ships with the handstrap installed. Before you install the
battery pack, you must remove the handstrap. Rotate the handstrap
hook 90 degrees left or right, and unhook it from the 243X.
243XU011.eps
2 Open the battery door.
Push down on the battery door latch and slide it toward the bottom
a
end of the 243X.
Lift up the bottom edge of the battery door to remove it. You may
b
need to use a pointed object to lift the door open. Remove the foam
insert if necessary.
3 Place the battery pack into the battery compartment with the contacts
pointed toward the bottom of the 243X.
4 Slide the battery pack down toward the bottom of the 243X until it
locks into the connectors in the battery compartment. See the next
illustration.
39 AGaramond
Handstrap
hook
b.
a.
243XU015.eps
Trakker Antares 243X Handheld Terminal User's Manual