Troubleshooting A Locked Up Application; Resetting The Terminal - Intermec Trakker Antares 243X User Manual

Chapter 4— Troubleshooting and Maintaining the Terminal

Troubleshooting a Locked Up Application

Resetting the Terminal

80
If the terminal or application is locked up and the terminal will not
respond to any key sequences, try the following to reset the terminal and
perform a warm boot.
To perform a warm boot
1 Press f or ' to turn off the terminal, and then press f or ' to
turn on the terminal.
2 Use the TRAKKER Antares 2400 Menu System to reboot the terminal.
Scan this bar code to enter the TRAKKER Antares 2400 Menu
a
System:
TRAKKER Antares 2400 Menu System
*..-.*
*..-.*
Choose System Menu, and then choose Upgrade Firmware.
b
Choose OK, choose YES, and then press the Esc key. The Boot
c
Menu appears.
Press 1 to boot the terminal.
d
3 Scan the Reset Firmware label to restart the firmware and application.
Reset Firmware
*-.*
*-.*
If the terminal or application still will not respond, reset the terminal. For
help, continue with the next section.
If you performed the steps in "Troubleshooting a Locked Up Application"
and the terminal or application is locked up and the terminal will not
respond to the Reset Firmware command, follow the steps in this section
to reset the terminal.
To reset the terminal
• Scan the Boot Terminal label to reboot the terminal.
Boot Terminal
*-.1*
*-.1*
If the terminal will not scan, you can cold boot the terminal and perform a
destructive reset. A destructive reset can have unpredictable results.
39
nugget
Trakker Antares 243X Handheld Terminal User's Manual