Using The Boot Menu - Intermec Trakker Antares 243X User Manual

Using the Boot Menu

Trakker Antares 243X Handheld Terminal User's Manual
39
nugget
Chapter 4— Troubleshooting and Maintaining the Terminal
There are two ways to configure the f key or the ' key using the
Resume Execution configuration command:
Resume Execution Not Allowed
Configures the terminal to boot and restart your application each time you
press f or ' to turn on the terminal. Use this option if you want to
restart your application every time you turn on the terminal.
Resume Execution Allowed
Configures the terminal to resume exactly where it was when you turned
off the terminal. Use this option to resume working each time you turn on
the terminal.
You can configure the Resume Execution command by using the
TRAKKER Antares 2400 Menu System or by scanning these bar code
labels. For help, see Chapter 2, "Configuring the Terminal," or see
"Resume Execution" in Chapter 6 of the 2400 Family system manual.
Resume Execution Not Allowed
*$+ER0*
*$+ER0*
To access the Boot menu, you can:
• upgrade the firmware. For help, see "Upgrading the Firmware" in
Chapter 2 of the 2400 Family system manual.
• reset the terminal. For help, see "Resetting the Terminal" on page 80.
• remove the main battery and wait longer than 15 minutes to install a
charged main battery. This procedure also performs a destructive reset,
which can have unpredictable results.
The next table describes the Boot Menu commands.
Boot Menu Commands
Command Description
Press 1 to boot the terminal. Once the terminal is finished
Boot System
booting, your application appears on the screen.
Press 2 to load the terminal firmware. To upgrade or load the
Run Loader
firmware, use the Firmware Upgrade option in the TRAKKER
Antares 2400 Menu System. For help, see Chapter 2, "Configuring
and Managing the Terminals," in the 2400 Family system manual.
Press 3 to turn off the terminal. When you turn on the terminal,
Power Down
the Boot Menu screen appears again if POST passes.
Resume Execution Allowed
*$+ER1*
*$+ER1*
79