Installing And Charging The Battery - Intermec CN2B User Manual

Installing and Charging the Battery

CN2B Mobile Computer User's Manual
Make sure you fully charge the battery before you use your CN2B Com-
puter. To charge the battery, you need to install it in the CN2B Computer.
To install and charge the battery
1 Push down on the battery door latch, and pull up on the battery door.
2 Remove the battery door and set it aside.
3 Align the battery contacts, and insert the battery in the battery compart-
ment. Press down on the battery until it clicks into place.
4 Replace the battery door.
5 Connect the AC power supply (P/N: 074246) to the power connector
on the back of the CN2B communications dock (P/N 225-696-001),
and then connect the power cord to the AC power supply.
You must use only the Intermec power supply approved for use with
the CN2B Computer. Using any other power supply will damage the
CN2B Computer.
Note: For help installing and using the communications dock, see the CN2
Communications Dock Quick Start Guide (P/N: 930-061-001), which
shipped with the dock.
Chapter 1 — Introduction
Battery door latch
Battery
5