Table of Contents
Advertisement
86 Operating the W
P
ITTKE
Warning!
Always apply the lockout/tagout procedure before entering the hopper area. See Locking
Out and Tagging Out the Vehicle on page 36
Packer Not Working?
If the packer does not cycle:
Read warning message on the display monitor. Refer to Table 1 in chapter 3 for a list of solutions.
1.
Ensure the hydraulic system is engaged.
2.
Pump switch on the control panel must be green-lighted (see Figure 3-16).
Check the emergency red button (see Figure 3-25).
3.
Pull it up if it has been pushed down.
Press the yellow button to ensure the packer is completely retracted (see Figure 3-27).
4.
Check around the packer for any obstruction preventing it from moving freely.
5.
Warning!
Always apply the lockout/tagout procedure before entering the hopper area. See Locking
Out and Tagging Out the Vehicle on page 36.
Check fuses and breakers on the console as well as the fuse located next to the battery box.
6.
Report your findings to the maintenance personnel.
7.
Unloading Refuse
Once the body of the W
for unloading purposes.
Preparing to Unload Refuse
To prepare your W
Find an appropriate dump location. The truck must be on solid, level ground. Adequate
1.
clearance must be provided to allow the tailgate to be fully opened and the refuse body to be fully
raised.
Caution!
Serious injury or mechanical damages could result if ground is unstable.
™
ENDULUM
P
ITTKE
ENDULUM
P
™ unit for unloading:
ITTKE
ENDULUM
™ is full, drive the unit to the landfill or an appropriate area
Advertisement
Table of Contents
