Right-Hand Side Driving Position (Optional) - Wittke Pendulum Operator's Manual

78 Operating the W P
ITTKE

Right-Hand Side Driving Position (optional)

If your unit is equipped with a right-hand side driving position, the following general procedure must
be followed when you need to change driving positions.
Before you operate your front-loader using the optional right-hand side driving position, take the
time to read the chassis manufacturer's manual so that you can exactly know what you have to do.
Also, check with your supervisor for regional rules about speed and safety restrictions.
When changing driving positions, follow these steps (general procedure):
Stop the vehicle and set the parking brake.
1.
Warning! Set the parking brake before leaving the cab for an extended period of time or when
stopping on an incline. Do not rely on work brake.
Turn off the hydraulic pump (see Pump Switch on page 58).
2.
Move to the desired driving position (LH or RH).
3.
Shift the O
4.
Figure 4-4 O P
PERATING
Adjust mirrors and monitor to the chosen driving position.
5.
Start the engine.
6.
Turn on the hydraulic pump (see Pump Switch on page 58).
7.
Warning!
Use the parking brake when leaving the cab for an extended period of time rather than the
right-hand side work brake (if equipped). Consult the chassis OEM.
Adjust the front loader arms to a position suitable for travel to the next stop.
8.
™
ENDULUM
P switch to the desired position (LH or RH).
PERATING OSITION
switch
OSITION