Table of Contents
Advertisement
Displayed in the lower center of the screen is an indicator that monitors traffic on the network. This
indicator is called Network Load, and it shows values that reflect such traffic.
: The higher the network load value is, the heavier the traffic is on the network.
N
OTE
To exit this page and return to the Main page, press "Esc". To choose a section from the Main Menu,
highlight the desired section using the up/down arrows and press the "OK" button.
Multicycle
Labrie's multiplexed system makes changing multicycle settings real easy! All you need is the display
monitor. Say you want to change the multicycle settings of the pendulum packer. Just select the
M
Page from the
ULTICYCLE
corner of the display monitor. Use the left and right arrows to select the desired number of packer
cycles and press "OK" to validate or Esc to cancel. The multicycle settings can be changed from one
to ten cycles.
Figure 3-5
M
page
ULTICYCLE
: The packer multicycle function has been preset at the factory to carry out five (5) cycles.
N
OTE
When the green button on the packer control station (see Figure 3-6) is activated, the packer will
move according to the default number of cycles (that is 5) or to the number of cycles you chose (up
to 10 cycles).
by pressing the corresponding button at the bottom left
MAIN MENU
Controls and Indicators 49
Advertisement
Table of Contents
