Wittke Pendulum Operator's Manual page 57

Table 2 Error messages (cont'd)
Module 25 is disconnected
Module 25 not Connected
Module 30 is disconnected
Module 30 not Connected
Module 50 is disconnected
Module 50 not Connected
Module 60 is disconnected
Module 60 not Connected
Should the system issue a warning or a caution message, it will appear on the Main page.
For example, if "Pump Not Started: Main Air Pressure" appears on the Main page of the display
monitor, the solution would be to wait until the required main air pressure level is reached.
For a specific problem or condition that requires special attention, the multiplexed system will
suggest a possible cause to the operator. This will appear in bold and large print on the monitor
screen (active cause). The operator should check if the problem stems from the highlighted or active
cause. One possible cause is highlighted at a time. What is shown in light and small print in the lower
part of the screen are causes that have already been dealt with (see Figure 3-4).
Error Messages Solution
Refer to Maintenance
Personnel or LabriePlus
Refer to Maintenance
Personnel or LabriePlus
Refer to Maintenance
Personnel or LabriePlus
Refer to Maintenance
Personnel or LabriePlus
Refer to Maintenance
Personnel or LabriePlus
Refer to Maintenance
Personnel or LabriePlus
Refer to Maintenance
Personnel or LabriePlus
Refer to Maintenance
Personnel or LabriePlus
Controls and Indicators 47