Speed-Up Switches (Optional) - Wittke Pendulum Operator's Manual

Figure 3-22 Forks width switches
: If this optional feature is available on your unit, these switches are located on the control
N
OTE
panel.

Speed-Up Switches (optional)

These switches (see Figure 3-16) engage/disengage the optional speed-up feature which is used to
increase the engine speed up to 1500 RPM whenever a pack or an auto-pack cycle is initiated.
The upper switch is used to engage the speed-up function which increases the engine speed until
disengaged.
Press this switch to engage the speed-up function (switch turns green).
Figure 3-23 Speed-up "ON"
Press this switch again to disengage the speed-up function (switch turns blue).
: The unit transmission must be in neutral before this speed-up switch can be turned on.
N
OTE
The lower switch is used to activate the auto setting for the speed-up function and increase the
engine speed up to 1500 RPM during packing and auto-packing cycles.
Press this switch to engage the "AUTO" speed-up function (switch turns green).
Controls and Indicators 63