Table of Contents
Advertisement
50 Controls and Indicators
Figure 3-6
Green S
TART
To test the new multicycle settings:
Press the green
1.
Once the packer has completed its cycles and comes to a stop, switch off the hydraulic pump and
2.
turn off the engine.
The number of cycles needs to be adjusted depending on the type of collection route used by the
vehicle. For example, if the pickups are numerous and close one to another, it may be required to
increase the number of cycles. This will allow the hopper to be clear for the next pickup.
Each time the packer completes a full cycle, the packer in "home" position proximity switch sends a
signal to the electronic module. The module then counts the amount of cycles that the packer does,
and will stop the packer after the preset amount of cycles has been reached.
I/O Status
In this section, you will find helpful information for troubleshooting body-related problems that you
may face in your day-to-day tasks. These problems can be of any kind: hydraulic, mechanical,
electrical or pneumatic.
Select the control module corresponding to the part of the truck that needs to be checked.
For example, if you want to check all functions that are found in the cab, choose module #10. For all
functions that pertain to the chassis, choose module #20, etc.
To choose a particular module, use the up/down arrows to select it and enter "OK".
: Entering "OK" can be done two ways: press either the far right button or the "OK" button.
N
OTE
Press "Esc" to return to the preceding page.
C
button
YCLE
button.
START CYCLE
Advertisement
Table of Contents
