Table of Contents
Advertisement
3.
Swing the bottom control linking bar
towards the centre of the fire to clear the right
side of the surround. Slide the surround unit
sideways, if necessary, to align the bottom fixing
holes with those in the hotbox. Fix the bottom of
the surround unit to the hotbox with two washers
and screws (See figure 29).
4.
Align the hole near the bottom of the
control linking bar with that in the control pivot
bracket. Join them with the knurled shouldered
screw (See figure 30). Make sure that the
isolating valve is closed. Slide the control
button fully from top to bottom and back
to make sure that the slide and pivot
mechanisms move smoothly. Note that
some resistance should be felt when the
slide button reaches the "burner fully on"
position.
5.
Fit the burner baffle to the front
flanges of the burner. To do this, place the
baffle against the front flanges of the
burner and lower into position. The return
edges on the rear of the baffle should slot
over the front flanges of the burner (See
figure 31).
INSTALLER'S GUIDE
Page 29
Figure 29. Front
Surround Bottom Location
Figure 30. Control Bar & Pivot
Bracket
Figure 31. Fitting the burner baffle
Hide quick links:
Advertisement
Table of Contents
