Status Leds; Setup - YASKAWA NX100 Instruction Manual

Fieldbus PCI-Card

Setup

14.2.1 Status LEDs

No:
1
2
3
4
5
6
Fieldbus interface
Fig. 55 9-pin D-sub male layout
14.3 Setup
Node address setting can be in the range: 1-62 and 64-255.
Node address restrictions:
• Node address 0 is reserved for the fieldbus control system (e.g. the PLC)
• Node address 63 is reserved for configuration and diagnostic terminals
• Addresses 1 - 62 are used for connecting industrial peripheral devices to FIPIO. These devices
Page 64
Indication
Appl. connected
I/O ACCESS
Run
COM
Err
I/O
Meaning
State
Green Controlled by application
Red Standalone
Green, flashing I/O access OK
Red, flashing I/O access failure (recoverable)
Off No activity
Off Device not powered or major failure
(no communication)
Green Normal operation (Device powered
up and operating)
Off No bus activity
Green, flashing Bus activity
Off Not powered or device operating
normally
Red, flashing Bus not connected or promptness
timeout
Red Major unrecoverable fault
Off Device operating normally
Red External device error
Reg.No. ME00107EN-02