Status Leds; Network Setup - YASKAWA NX100 Instruction Manual

Fieldbus PCI-Card

Network setup

13.2.1 Status LEDs

No: Indication
Appl.
1
connected
2 I/O ACCESS
3 COM
4 LNK
5 FL-LNK
6 ERR
Fieldbus interface
Fig. 53 RJ45 female layout
Pin RJ45
(Female)
1
2
3
4
5
6
7
8
13.3 Network setup
The IP address on the board is set with the HMS "Anybus IPconfig" tool which can be downloaded
from the HMS support webpage.
See section 4 General installation in IP-based networks.
Page 62
Meaning
State
Green Controlled by application
Red Standalone
Green, flashing I/O access OK
Red, flashing I/O access failure (recoverable)
Off No activity
Green Packet received or transmitted
Off No activity
Green Link established
Off No link established
Green Participating on FL-Net
Off Not participating on FL-Net
Red Unit needs to be replaced (e.e. invalid MAC ID)
or
Anybus watchdog enabled and not updated properly
Red, flashing Parameter error
Off Normal state
1
Signal
TD+
TD-
RD+
Termination
Termination
RD-
Termination
Termination
8
Reg.No. ME00107EN-02