YASKAWA NX100 Instruction Manual page 61

Fig. 46 Anybus Master EtherNet/IP
A. Scanner mode Idle
Note
If Scanlist Config is missing, update the HMSAB.DRV in the robot controller or the firmware
on the PCI card.
To enter Configuration of Scanlist, select text "Scanlist Config":
Fig. 47 Anybus Master EtherNet/IP 2
A. Delete
B. Add
If you try to add or edit the scanlist when the module is in RUN-mode the following error will be
displayed:
Reg.No. ME00107EN-02
Fieldbus PCI-Card
A
B
B. Scanlist Config
Network setup
A
B
Page 55