Connectors; Devicenet Network Setup - YASKAWA NX100 Instruction Manual

Fieldbus PCI-Card

DeviceNet network setup

No:
5
6

7.2.2 Connectors

Application interface
The module is available in both serial and parallel versions.
Fieldbus interface
Fig. 23 Male Connector DeviceNet
No:
1
2
3
4
5
Note
The layout in Fig. 23 Male Connector DeviceNet is for a male connector. Female connectors
are in the opposite order.
7.3 DeviceNet network setup
For a complete network setup See 8.3 DeviceNet network setup. Each slave device in a DeviceNet
network is associated with an EDS-file which has to be downloaded to the network.
Page 34
Indication
Network status
Module status
1 2
Signal Decription
V- Negative supply voltage
CAN_L CAN_L bus line
shield Cable shield
CAN_H CAN_H bus line
V+ Positive supply voltage
Meaning
State
Off No power or not online
Green Link OK, online, connected
Green, flashing Online not connected
Red Critical link failure
Red, flashing Connection timeout
Off No power to device
Green Device operational
Green, flashing Data size greater than configured
Red Unrecoverable fault
Red, flashing Minor fault
3 4 5
Note
The module requires 24VDC bus
power
The module requires 24VDC bus
power
Reg.No. ME00107EN-02