Change Settings - YASKAWA NX100 Instruction Manual

Auto address
This command is used to enable/disable the automatic address programming feature.
Fig. 38 Auto address
Press [ESC] to cancel.
Save configuration
Fig. 39 Save configuration
Press [Enter] to store the current configuration, or press [ESC] to cancel.
Note
This command is not allowed in protected mode.

9.4.2 Change settings

This menu is displayed when a specific node has been selected in main menu commands 1 to 4.
Reg.No. ME00107EN-02
Fieldbus PCI-Card
Configuration interface
Page 47