Connectors; Rectifying Of Interruption - YASKAWA NX100 Instruction Manual

Fieldbus PCI-Card
Card
No:
4
5
6

9.2.2 Connectors

Fig. 27 Connector PCI AS-interface Master
No:
1
2
3

9.2.3 Rectifying of interruption

Since there are possibilities of AS-interface being affected by interruption, a ferrite clip should be
attached to its bus cable according to Fig. 28 Ferrite clip on cable.
Fig. 28 Ferrite clip on cable
Page 40
Indication
Auto prog, slave 0 exist
Network status
Module status
1
Signal
AS-Interface +
-
AS-Interface -
Meaning
State
Off No error, no slave 0,
autoprogrammming not possible
8Hz Green Auto programming possible
1Hz Green Slave address 0 exist
Red Periphery error
8Hz Red Perophery error, auto-programming
possible
1Hz Red Periphery error, slave address 0 exist
Off No power or not initialized
Green, flashing online according to configuration
Green Online, but no connections
established
Red Offline
Off No power or not initialized
Green, flashing Protected mode
Green Configuration mode
Red Power fail bus
2 3
Reg.No. ME00107EN-02