YASKAWA NX100 Instruction Manual page 6

Fieldbus PCI-Card
Registered Trademark
• Perform the following inspection procedures prior to conducting
manipulator teaching. If problems are found, repair them
immediately,
and be sure that all other necessary processing has been
performed.
– Check for problems in manipulator movement.
– Check for damage to insulation and sheathing of external wires.
• Always return the programming pendant to the hook on the cabinet
of the controller after use.
The programming pendant can be damaged if it is left in the
manipulator's work area, on the floor, or near fixtures.
• Read and understand the Explanation of Warning Labels in the
controller Instructions before operating the manipulator:
In this manual, names of companies, corporations, or products are
trademarks, registered trademarks, or bland names for each company or
corporation. The indications of (R) and
vi
CAUTION
TM
are omitted.
ME00107EN
170542-1CD