Tub Assembly Removal - Ricoh M126 Service Manual

4.2.40 TUB ASSEMBLY REMOVAL

1. Flatbed assembly (
2. Disconnect the remaining cables from the controller board.
3. Thread the cables through the tub assembly and top cover.
4. Controller board cage (
5. Operator panel keyboard (
6. Operator panel display (
7. Left rear frame assembly (
8. Right rear frame assembly (
9. USB cable mount bracket (
10. Operator panel support (
11. Operator panel display rotation support (
12. Remove the top and side screws securing the left flatbed support.
13. Left flatbed support.
14. Remove the top and side screws securing the right flatbed support.
15. Right flatbed support.
16. Lift the tub assembly off the machine.

After removing the tub assembly, remove the output bin LED and LED cover
( p.4-83 "Output Bin LED and Lens Removal"). These will be used on the new tub
assembly.
SM
p.4-73 "Flatbed Removal")
p.4-12 "Controller Board Cage")
p.4-51 "Operator Panel Keypad Removal")
p.4-52 "Operator Panel Display Removal")
p.4-56 "Left Rear Frame Assembly Removal")
p.4-58 "Right Rear Frame Assembly Removal")
p.4-55 "USB Cable Mount Bracket Removal")
p.4-55 "Operator Panel Support Removal")
p.4-56 "Display Rotation Support Removal")
4-59
Removal Procedures
M126/M127/M128