Ricoh M126 Service Manual page 228

Error
Imaged page not expected page
200.06
(bouncy passthru sensor)
Media reached the input sensor before
200.08
the EP was ready
200.09 Transfer servo never started
Media detected at manual feeder
sensor when not expected. Possible
200.12 causes include user insert of media
when motor is running or pre-staged
media in the tray.
The input sensor is covered when the
200.13 media is not expected (media in
machine during warm-up)
Trailing edge cleared manual feed, but
did not successfully debounce the
200.14
sensor. Potential causes are a small
gap or a bouncy manual feed sensor.
SM
Description
6-23
Messages and Error Codes
Action
Remove the toner cartridge/PC kit.
At the front, remove the upper front
guide, and inspect the flag on the
manual input sensor. If the flag is
loose, then replace it. See "Media
Manual Input Sensor" in
"Replacement and Adjustment".
Inspect the tray for prestaging.
Verify the proper media and inspect
the tray wear strips. Replace the
wear strips if necessary.
Inspect the LVPS/HVPS. See
"Engine Board Service Check" in
"Troubleshooting".
Carefully remove the tray and notice
if the leading edge of the media is
pointed upward and out of the tray. If
so, then inspect the tray wear strips
and replace if necessary.
Inspect the input sensor flag and
replace it if it does not rotate freely
or is too loose.
Remove the toner cartridge/PC kit
and inspect the input sensor flag.
Replace the flag if necessary.
Remove the toner cartridge/PC kit.
At the front, remove the upper front
guide, and inspect the flag on the
manual input sensor. If the flag is
loose, then replace it. See "Media
Manual Input Sensor" in
"Replacement and Adjustment".
M126/M127/M128