Cooling Fan Service Check; Card Reader Service Check - Ricoh M126 Service Manual

6.5.3 CARD READER SERVICE CHECK


The card reader cover will need to be removed, and the op panel keyboard assembly will
need to be removed to verify the cable connections (
Removal").
FRU
Card reader cable
Card FRU
Controller Board

6.5.4 COOLING FAN SERVICE CHECK

FRU
Cooling fan
SM
Verify that the card reader USB cable is properly connected
to the card reader card.
Make sure the card reader USB cable plug is properly
seated at J2 (controller board).
Try a different USB cable to connect the card reader card to
the controller ( p.4-6 "Card Reader Cable Removal").
Replace the card reader FRU (
Removal"). If this does not fix the problem, replace the
controller board ( p.4-7 "Controller Board Removal").
Make sure the fan cable plug is properly seated at J36
(engine board).
Turn the machine on. Within a few seconds, the engine
board assembly should apply +24Vdc to pin2.

If voltage is not present, then check or replace the
engine board ( p.4-13 "Engine Board Removal").

If voltage is present, then check pin 1 for 24 V dc as
well. If it is close to 24 V dc while the fan is still idle,
then replace the fan (
6-55
p.4-6 "Card Reader Cable
Action
p.4-4 "Card Reader
Action
p.4-20 "Fan Removal").
M126/M127/M128
Service Checks