Received Fax Has Poor Print Quality; Solving Option Problems; Option Does Not Operate Correctly Or Quits After It Is Installed - Ricoh M126 Service Manual

Received fax has poor print quality

These are possible solutions. Try one or more of the following:
R -
E SEND THE DOCUMENT
Ask the person who sent you the fax to:
•
Check that the quality of the original document is satisfactory.
•
Resend the fax. There may have been a problem with the quality of the telephone line connection.
•
Increase the fax scan resolution, if possible.
T
HE TONER MAY BE LOW
When 88 Cartridge low appears or when you experience faded print, replace the cartridge.
M
AKE SURE THE FAX TRANSMISSION SPEED IS NOT SET TOO HIGH
Decrease the incoming fax transmission speed:
1
Type the printer IP address into the address field of your Web browser.
Note: If you do not know the IP address of the printer, then print a network setup page and locate the IP address
in the TCP/IP section.
2
Click Settings.
3
Click Fax Settings.
4
Click Analog Fax Setup.
5
In the Max Speed box, click on one of the following:
2400
4800
9600
14400
33600
6
Click Submit.

Solving option problems

Option does not operate correctly or quits after it is installed

These are possible solutions. Try one or more of the following:
R
ESET THE PRINTER
Turn the printer off, wait about 10 seconds, and then turn the printer on.
Troubleshooting
275