Require Standby; Les Applications; Key Repeat Initial Delay - Ricoh M126 Service Manual

5.2.27 REQUIRE STANDBY

This setting determines if the Standby Mode is "On" or "Off". The default is "On".
To change this setting:
1. Touch "Require Standby" from the Configuration Menu.
2. Touch "Back" to cancel and return to the Configuration Menu.
3. Touch "Submit" to save the change.
If Standby Mode is on, the machine begins functioning in Standby Mode when it remains idle for
an amount of time. The Standby Mode enables the machine:

To consume less energy than when operating in normal mode but not as little as when
operating in Power Saver

To return to the Ready state more quickly than when operating in Power Saver

5.2.28 LES APPLICATIONS

This disables all installed LES applications. The default is "Enabled".
To change this setting:
1. Touch "LES Applications" from the Configuration Menu.

If an advanced password has been established, you must enter this password in
order to change the setting. If no advanced password exists, you can establish one
by using the keyboard that appears on the LCD.
2. Touch "Back" to cancel and return to the Configuration Menu.
3. Touch "Submit" to save the change.

5.2.29 KEY REPEAT INITIAL DELAY

When a key is touched repeatedly, this is the delay before the key begins repeating. The delay
ranges from .25 seconds to 5 seconds. The default is 1 second. Values are given in increments
of .25 seconds.
To change this setting:
1. Touch "Key Repeat Initial Delay" from the Configuration Menu.
2. Touch to increase the value or
3. Touch "Submit" to save the change.
4. Touch "Back" to cancel and return to the Configuration Menu.
SM
Configuration Menu (CONFIG MENU)
to decrease the value.
5-21 M126/M127/M128