Adf Paper Jam Service Check - Ricoh M126 Service Manual

6.5.26 ADF PAPER JAM SERVICE CHECK


This service check should be used if the paper feeds and jams in the ADF. If the paper is
not feeding into the ADF see "ADF Feed Errors Service Check" in "Troubleshooting".
Step Questions / actions
If the ADF is multi-feeding, check for
dirt on the ADF separator pad and
1
ADF separator rollers. Are they
dirty?
f the paper is skewing when it is fed
2 into the ADF, check the paper guide
width. Is it set correctly?
If paper is skewing when fed or
jamming check to see if the top
3
cover is open or ajar. Is the ADF top
cover open or ajar?
4 Is paper failing to feed into the ADF? Go to step 5.
Perform the ADF paper present,
scan 1st and scan 2nd sensor tests.
5 See "Scanner Tests" in "System
Maintenance". Are the sensors
working properly?
Check the leading edge of the paper
to ensure the paper is not curled or
6 bent in a way that would keep it from
contacting the paper present sensor
actuator. Is the paper damaged?
Is there dirt in the sensors, or is the
7
paper present actuator stuck?
M126/M127/M128
Yes
Clean them with a
lint free cloth and
isopropyl alcohol.
Go to step 3.
Properly close the
top cover.
Go to step 6
Bad media.
Clean the sensors,
or remove debris
from the actuators.
6-94
No
Replace the
separator pad and
ADF pick roll.
Set the paper
guides so they
contact the edges
of the paper.
If the paper is
jamming in the
ADF, go to step 6
There is no issue.
Go to step 9.
Go to step 7.
Go to step 8.
SM