Print Tests; Quick Test Page; Input Sources - Ricoh M126 Service Manual

Quick test page

The Quick Test contains the following information:

Device information

Printer margin settings

Scanner margin settings

Alignment diamonds at the top, bottom, and each side.

Horizontal lines for skew adjustment

General machine information, including current page count, installed memory, processor
speed, serial number, Engine ID, and system card ID.
To print the Quick Test page:

Print the Quick Test Page on letter or A4 paper.
1. Touch "REGISTRATION" from the Diagnostics Menu.
2. Touch to select Quick Test. The message "Quick Test Printing..." appears on the display.
Once the Quick Test Page completes printing, the Registration screen displays again.
3. Touch "Back" to return to the Diagnostics Menu.

5.3.3 PRINT TESTS

This setting tests the machine's ability to generate printed output from each of its installed input
sources and to test the machine's current print quality.

Input sources

The purpose of the diagnostic Print Tests is to verify that the machine can print on media from
each of the installed input options. The contents of the Print Test Page varies depending on the
media installed in the selected input source.
Check each Test Page from each source to assist in print quality and paper feed problems.
To run the Print Test Page:
1. Select PRINT TESTS from the Diagnostics menu.
2. Select the media source to test:
Tray 1
Tray 2 (if installed)
MP Feeder
Envelope Feeder/MP Feeder
3. Select "Single" or "Continuous".

If "Single" is selected, a single page is printed.

If "Continuous" is selected, printing continues until "Stop" is pressed to cancel the test.
If a source is selected that contains envelopes, an envelope test pattern is printed. If
SM 5-27
Diagnostics Menu
M126/M127/M128