Ricoh M126 Service Manual page 554

Menu item
Dialing Prefix Rules
Prefix Rule <x>
Automatic Redial
0–9
Redial Frequency
1–200
Behind a PABX
Yes
No
Enable ECM
Yes
No
Enable Fax Scans
On
Off
Driver to fax
Yes
No
Allow Save as Shortcut
On
Off
Dial Mode
Tone
Pulse
Max Speed
2400
4800
9600
14400
33600
Custom Job scanning
On
Off
Scan Preview
On
Off
Description
Establishes a dialing prefix rule
Specifies the number of times the printer tries to send the fax to a specified number
Note: 5 is the factory default setting.
Specifies the number of minutes between redials
Note: 3 is the factory default setting.
Enables switchboard blind dialing without a dial tone
Note: No is the factory default setting.
Enables Error Correction Mode for fax jobs
Note: Yes is the factory default setting.
Lets you send faxes by scanning at the printer
Note: On is the factory default setting.
Allows driver to fax jobs to be sent by the printer
Note: Yes is the factory default setting.
Lets you save fax numbers as shortcuts in the printer
Note: On is the factory default setting.
Specifies the dialing sound, either as a tone or a pulse.
Note: Tone is the factory default setting.
Specifies the maximum speed in baud at which faxes are sent
Note: 33600 is the factory default setting.
Lets you scan a document that contains mixed paper sizes into a single file
Notes:
•
A printer hard disk must be installed in the printer and operating properly for
this menu item to be available.
•
On is the factory default setting.
Specifies whether a preview will appear on the display for scan jobs
Notes:
•
A printer hard disk must be installed in the printer and operating properly for
this menu item to be available.
•
Off is the factory default setting.
Understanding printer menus
195