Table of Contents
Advertisement
1.4.7
Door Latch Inspection
The door latch must hold the door closed and ensure that the switch activation tab is
depressing the door switch [1]. The switch tab [2] should press the switch button just
so that it is close to bottoming.
Maintenance Schedule
Inspect every 750K cycles.
Procedure
•
Ensure latch holds door closed.
•
Ensure switch is activated when the door is closed.
•
To adjust the door latch, see "Door Latch" on page 4.2.1.
[2]
1.4.8 Separating Punch from Printer
Some procedures require separating the StreamPunch Pro from the printer and
finisher.
Refer to "Separating the Punch from the Printer" on page 4.1.1.
1.4.9 Rear Cover Removal
Some procedures require the removal of the rear cover. Refer to "Removing the Rear
Cover" on page 4.1.2.
Figure 1.13 Door Switch Tab and Switch.
25
[1]
Advertisement
Table of Contents
