Sb67040 Cordless Handset Installation; Charger Installation - AT&T Synapse Installation Manual

SB67040 Cordless Handset Installation

The SB67040 Cordless Handset requires registration to an SB67030 Deskset. The SB67020 Deskset does not support the
SB67040 Cordless Handset.
The SB67040 Cordless Handset is not supported when the system is in Line Appearance mode.

Charger Installation

Place the Handset in the charger when not in use.
To plug the Handset charger into AC power:

Figure 43. Handset Charger Power Connect
Installation
Synapse Installation Guide
1. Plug the power adapter into an electrical outlet not controlled by a
wall switch.
2. Plug the small end of the power adapter into the jack on the
underside of the charger.
3. Route the cord through the slot, as shown in Figure 43.
58