T1 Diagnostics - AT&T Synapse Installation Manual

T1 Diagnostics

These settings apply to Call Appearance mode only.
You can check the status of the T1 Gateway and select a loopback mode. Setting the loopback mode terminates any phone calls
that are using the T1 Gateway.
To view the T1 Status:

Figure 124. T1 Diagnostics
System Configuration
Synapse Installation Guide
1. In the Navigation Menu at left, click System Settings, then T1
Diagnostics. The page shown in Figure 124 appears.
The current T1 configuration is shown.
2. Optional: Put the T1 in loopback test mode by selecting from the
Set Loopback Mode drop-down list, then clicking
that the Alarm State color changes accordingly.
Selecting Network loopback allows the service provider to test
the T1 circuit.
Selecting Payload loopback allows the service provider to test
both the circuit and the T1 Gateway's ability to encode and
decode the T1 data.
Once loopback testing is completed, select None, then click
to cancel any loopback test mode.
Be sure to cancel loopback testing so that telephone calls
can again occur.
114
. Note