Gateway Installation - AT&T Synapse Installation Manual

Gateway Installation

To install the Gateway:

1. Install a Gateway first. Plug the AC plug into an electrical outlet not controlled by a wall switch and the DC plug into the
DC jack, as shown in Figure 20. Wait up to one minute until the screen lights up.
2. Plug a grey Cat.-5 LAN cable for the PSTN Gateway or yellow Cat.-6 LAN cable for the T1 Gateway into the Ethernet port
marked LAN. Use the supplied cables or a comparable substitute. Plug the other end of the cable into your office LAN. The
T1 Gateway is Gigabit Ethernet (GigE) capable, so it has a Cat.-6 LAN cable. The Desksets and other devices require only
Cat.-5 cables.
.
PSTN Gateway
T1 Gateway
Installation
Synapse Installation Guide
Figure 20. Gateway Power and LAN Connections
41
LAN DC Power