Wall Mounting - AT&T Synapse Installation Manual

Wall Mounting

To mount the Gateway or ATA to a wall:

Figure 17. Gateway Wall
Mounting
Installation
Synapse Installation Guide
You can mount the Gateway or ATA to a wall using the two mounting slots on the bottom of
the device. Ensure that the device is oriented as shown in Figure 17 to allow air to flow
vertically through the ventilation holes on each side of the device.
1. Install two pan-head screws (with ¼-inch diameter head) 7 ⅞ inches (20 cm) apart. The
screw shaft diameter should be ⅛-inch (3.2 mm). Ensure you use anchors appropriate for
your mounting surface. Leave about ⅛-inch (3.2 mm) clearance between the screw head
and the wall.
2. Position the device with the mounting slot centers aligned over the mounting screws.
Carefully bring the device down onto the screws.
3. Slide the device downwards so that the screws go into the mounting slots on the device.
Ensure the device is secure.
38