Printing While Emulating Hp-Gl/2 And Hp Rtl; Switching Roll Paper Automatically Before Printing; (T7270D/T5270D Only); Switching To Roll 1/Roll 2 By Paper Type - Epson SureColor T-Series User Manual

Epson SureColor T-Series User's Guide
Printing while Emulating
HP-GL/2 and HP RTL
*
The printer can emulate HP-GL/2 (compatible with
HP Designjet 750C) and HP RTL.
When you want to print with applications using
HP-GL/2 or HP RTL output, configure the output
equipment as shown below according to your model.
O T7270/T7270D/T5270/T5270D
HP Designjet 750C C3195A
O T3270
HP Designjet 750C C3196A
* Not all functions are supported. If you will use an
untested application, test its output in advance.
For a list of applications that have been tested, visit the
Epson website at http://www.epson.com.
Important:
c
The printer may not perform as expected if the
volume of the data to be printed is extremely
large.
When you will print while emulating HP-GL/2 and HP
RTL, observe the following points.
O Select Paper Type setting
Set one of the following options for the Select
Paper Type setting of the printer. If other paper
types are used, print quality may be reduced.
Singleweight Matte/Plain Paper/Tracing
Paper/Tracing Paper <Low Duty>
O HP-GL/2 Settings
When you will print while emulating HP-GL/2 and
HP RTL, set the Print Settings as follows: On the
printer, select Setup menu > Printer Setup >
HP-GL/2 Settings.
U"Setup menu" on page 139
More Ways to Print
Switching Roll Paper
Automatically before
Printing (T7270D/T5270D
Only)
Explanations in this section use a typical method to
switch automatically to the appropriate roll paper for
the print job.
Switching to Roll 1/Roll 2 by
Paper Type
For example, when you use the following method
often, if you use the settings described below, the
printer can switch between Roll 1 and Roll 2
automatically in accordance with the paper type.
Usage example
You use different types of paper depending on the
purpose of its use. For example you print to plain paper
for drawings for in-house checks and print to color
print paper for presentations and drawings for clients.
In this example, the paper is loaded as follows. All
paper has the same width.
Roll 1: Plain Paper
Roll 2: Singleweight Matte Paper
Settings on Windows
Using the control panel of the printer, confirm
1
Type Match is set in Setup menu > Printer
Setup > Roll Paper Setup > Roll Switch
Condition > Paper Type.
The default Paper Type setting is Type Match.
If the setting has not been changed, the setting is
Type Match.
U"Setup menu" on page 139
Open the Printer Settings tab of the printer
2
driver and confirm that Source is Roll Auto -
XXXXX.
XXXXX indicates the width of the roll paper
currently in use.
87