Epson SureColor T-Series User Manual page 170

Epson SureColor T-Series User's Guide
Messages
Paper Size Error
Loaded paper is not supported
size.
Paper Sensor Error
Loaded paper or print out has a
problem.
Refer to manual for details.
Roll Setting Error
Specified roll paper is not loaded.
Continue to print with paper
currently loaded?
Paper Type Error
Cannot switch to specified roll
paper because paper type is
different.
Continue to print with paper
currently loaded?
Paper Width Error
Cannot switch to specified roll
paper because paper width is
different.
Continue to print with paper
currently loaded?
Problem Solver
What to do
The loaded paper width is not supported. Press the Z button and remove the paper.
Paper for use in the printer must be at least 254 mm wide. Use paper that is at least 254
mm wide.
Should this message be displayed with paper of a width that can be used in the printer,
you may be able to print if you select Off for Paper Size Check in the Setup menu.
U"Setup menu" on page 139
Press the W button to clear the error from the control panel.
If this error is displayed when performing automatic head alignment, check the
following items.
Does the paper support auto head alignment?
O
Head alignment is not available with transparent or colored media, tracing paper,
paper not supported by the auto head alignment function, or paper that is 1.0 mm
or more thick.
See the following for information on the types of paper that support auto head
alignment.
U"Epson Special Media Table" on page 187
Are outside light sources interfering with the process?
O
If the printer is exposed to direct sunlight or another light source that causes optical
interference, shade the printer from these sources.
Are the default values selected for both Platen Gap and Less Head Scuffing?
O
Restore both items to their default values.
Are some print head nozzles clogged?
O
Perform head cleaning. U"Head Cleaning" on page 157
If this error is displayed in circumstances other than those listed above, check that the
printer supports the current paper.
In Source of the printer driver, roll paper which is not loaded is selected.
If the Z button is pressed, the printer is forced to print using the loaded roll paper.
If the ( button is pressed, paper can be loaded.
The Media Type setting of the printer driver and the paper type of the roll paper loaded
on the printer are different.
If the Z button is pressed, the printer prints to the roll paper currently in use.
If the ( button is pressed, paper can be switched.
If you want to switch a roll paper even though it is a different type, open the Setup menu,
and then under Roll Switch Condition, change Paper Type to Disable.
U"Setup menu" on page 139
The Source setting of the printer driver and the width of the roll paper loaded on the
printer are different.
If the Z button is pressed, the printer prints to the roll paper currently in use.
If the ( button is pressed, paper can be switched.
If you want to switch a roll paper even though it is a different paper width, open the
Setup menu, and then under Roll Switch Condition, change Paper Width to a setting
other than Width Match.
U"Setup menu" on page 139
170