Removing Cut Sheets; Loading And Removing Poster Board; Loading Poster Board - Epson SureColor T-Series User Manual

Epson SureColor T-Series User's Guide

Removing Cut Sheets

This section describes how to remove cut sheets when
printing is complete.
Note:
To remove paper that was loaded but not used, press the
( button and select Remove Paper.
Buttons that are used in the following settings
Confirm that Paper Eject is displayed in the
1
control panel.
Keeping a hand on the cut sheets to prevent
them falling from the printer, press the Z
button.
The paper will be fully ejected from the printer
2
and can then be removed by hand.
Basic Operations
Loading and Removing
Poster Board
This section describes how to load and remove poster
board from 0.8 to 1.5mm thick.
The printer can be used with board of the following
sizes.
A2/A1/B2/B1
*
inch
* Not supported by the T3270.

Loading Poster Board

Poster board requires space both behind and in front of
the printer. The approximate amount of space required
is shown below. If the printer is set up near a wall, make
sure there is enough space at the rear.
Paper Size
A2
A1
24 × 30 inch
30 × 40 inch
Important:
c
Insert the paper just before printing. The roller
may leave an impression on paper that is left in
the printer.
39
* * /24 × 30 inch/30 × 40
/B1 landscape
Front (a) Back (b)
17.4 inches
(444 mm)
27.2 inches
(691 mm)
24.1 inches
(612 mm)
34.1 inches
(866 mm)
5.3 inches
(135 mm)
15.0 inches
(382 mm)
11.9 inches
(303 mm)
21.9 inches
(557 mm)