Table of Contents
Advertisement
The roll rewinds and the paper's leading edge returns to the print wait position.
Parent topic:
Related references
Paper Setting Menu
Removing Roll Paper
When you finish printing on roll paper, remove it from the printer to avoid indenting or creasing the paper.
Note: If you enabled Remaining Amount Management, the printer prints a barcode on the leading
edge of the roll when you remove the roll paper. When you reload the paper, the printer reads the
barcode and automatically sets the paper type and amount remaining.
1. Confirm that Ready to print appears on the LCD screen and then select Eject Paper.
Note: If printed paper is not cut and remains loaded in the printer, a confirmation message appears.
Select Cut to cut the paper at the default cut position or select Print Cutting Guideline to print a
cutting guideline at the default position. If you want to change the position of the cut or cutting
guideline, select Close to cancel the message and then select the
position.
2. Select How To... on the control panel and follow the on-screen instructions to remove the roll paper.
Parent topic:
Cut Sheet Handling
You can load a variety of types and sizes of cut sheet paper in your product.
Loading Cut Sheets in the Paper Cassette
Loading Cut Sheets in the Rear Manual Feeder
Loading Media in the Front Manual Feeder
Parent topic:
Loading Cut Sheets in the Paper Cassette
You can print on a variety of paper types and sizes from 8 × 10 inches (203 × 254 mm) to A2
(16.5 × 23.4 inches [420 × 594 mm])/17 × 22 inches (432 × 559 mm), 8 to 17 in. (203 to 432 mm) wide,
10 to 23.4 in. (154 to 594 mm) long, and 0.003 to 0.01 in. (0.08 to 0.27 mm) thick from the paper
cassette.
Cutting Roll Paper
Roll Paper Handling
Media Handling
60
cut icon to change the
Advertisement
Table of Contents
