JUKI DDL-8700A-7 Instruction Manual page 8

1ø 100V-120V
White
220V-240V
Green/
Black
Yellow
White
3ø 200V-240V
Black
Green/
Yellow red
3) Securely fix the terminals of the AC input cord
by tightening the screws at the specified loca-
tons.
4) Close the power swtch cover. Tghten screw 1
on the sde face of the power swtch cover.
WarNING :
1. Be sure to attach the ground wire (green/yellow) to the specified location (on the ground side).
2. take care not to allow terminals to come in contact with each other.
3. When closing the power switch cover, take care not to allow the cord to be caught under it.
3ø 200V-240V
1ø 100V-120V
220V-240V
Black
ac 200V-240V
red
White
Green / Yellow
(ground wire)
Black
ac 100V-120V
ac 220V-240V
White
Green / Yellow
(ground wire)
3
– 5 –
Pedal sensor cable ac cable
Staples (small)
Pedal sensor
5) Frstly attach the staple suppled wth the unt as
accessores to the cable. Then, hammer them
nto the sewng machne table.
At ths tme, attach the staples at the locatons
shown in the figure.
6) Connect the power cord to the power plug.
As shown in the figure, connect the white and black
(and red) wres to the power supply sde and the
green/yellow one to the groundng sde.
(caution) 1. Be sure to prepare the power plug
which conforms to the safety stan-
dard.
2. Be sure to connect the ground lead
(green/yellow) to the grounding side.
7) Check that the power swtch s n the OFF state.
Then, nsert the power plug comng from the power
swtch nto the plug receptacle.
(caution) In prior to the connection of the power
plug, re-check the supply voltage speci-
fication indicated on the power box.
Power switch
Staples
(large)
cable draw-out
hole
3