Setting The Bobbin Into The Bobbin Case; Adjusting The Stitch Length; Presser Foot Pressure; Hand Lifter - JUKI DDL-8700A-7 Instruction Manual

11. Setting the bobbin into the bobbin case

B
C

12. adjusting the stitch length

1

13. Presser foot pressure

B A
29 to 32 mm
2

14. Hand lifter

A
A
1
– 2 –
) Pass the thread through thread slt A , and
pull the thread n drecton C . By so dong, the
thread wll pass under the tenson sprng and
come out from notch B .
2) Check that the bobbn rotates n the drecton of
the arrow when thread s pulled.
* The dal calbraton s n mllmeters.
) Turn sttch length dal 1 n the drecton of the
arrow, and algn the desred number to marker
dot A on the machne arm.
) Loosen nut 2 . As you turn presser sprng regu-
lator 1 clockwse (n drecton A ), the presser
foot pressure wll be ncreased.
2) As you turn the presser sprng regulator counter-
clockwse (n drecton B ), the pressure wll be
decreased.
3) After adjustment, tghten nut 2 .
The standard value of the pressure regulatng thumb
screw s 29 to 32 mm.
) The presser foot s lfted by movng the lever
upward.
2) The presser foot s lowered by movng the lever
downward.