Set-Up; Installation - JUKI DDL-8700A-7 Instruction Manual

@. SEt-uP

1. Installation

) Carry the sewng machne wth two persons as
shown in the figure above.
(caution) Do not hold the handwheel.
3
1
Needle bar side
4
1
23.5mm
2
a
Fx two rubber seats 1 on sde a (operator's sde) usng nals 2 as llustrated above. Fx two cushon seats
4)
3 on sde B (hnged sde) usng a rubber-based adhesve. Then place under cover 4 on the fixed seats.
9
5) Ft knee lfter pressng rod 6 . Ft hnge 7 into the opening in the machine bed, and fit the machine head
to table rubber hnge 8 before placng the machne head on cushons 9 on the four corners.
6) Securely attach head support rod !0 to the table untl t goes no further.
(caution) Be sure to install the machine head support bar supplied with the unit.
7) Draw out cable !1 of the control box through cable draw-out hole !2 to route t to the undersde of the
sewng machne table.
8
3
1
19.5mm
3
B
6
7
– 3 –
2) Do not put protrudng artcles such as the screw-
drver and the lke at the locaton where the sew-
ng machne s placed.
3) The under cover should rest on the four cor-
ners of the machne table groove. Mount rubber
hnge seat 8 on the table and fix it on the table
wth a nal.
control box side
1
23mm
2
a
!1
!2
8
!0
4
19.5mm
3
B
7