Connection Of The Material End Sensor - JUKI DDL-8700A-7 Instruction Manual

16. connection of the material end sensor

1
Pn No. Sgnal name
 +12V
2 +5V
3 OPT_S
4 GND
Remarks
Power supply s selected
accordng to the sensor
used.
Sensor nput s assgned to
the materal end sensor.
) Open the cover referrng to
the rear cover"
2) Connect the connector of materal end sensor to
connector 1 (CN54 : 4P).
3) Assgn CN54 to the materal end sensor nput
"#-8- 8 . Selection of the optional
referrng to
input/output function (Function setting No.
12) p.34.
4) To use the materal end sensor, set up the sen-
sor functons on the control box through the
functon settng procedure. Selectable functons
and the correspondng selecton numbers are as
follows:
・ Materal end sensor functon (functon settng No. 2)
The materal end sensor s enabled.
2
0: Materal end sensor s not used.
: Materal end sensor s enabled.
・ Thread trmmng functon by means of the mate-
ral end sensor (functon settng No. 3)
The automatc thread trmmer s actvated after
the detecton of the materal end.
3
0: Automatc thread trmmng s not carred out.
: Automatc thread trmmng s carred out.
・ The number of sttches after the actvaton of the
materal end sensor (functon settng No. 4)
The number of sttches to be sewn untl the sew-
ng machne stops after the materal end sensor
has detected the material end can be specified.
4
Data settng range: 0 - 9 </sttch>
・ One-shot functon (functon settng No. 76)
The one-shot operaton untl the materal end s
detected can be set.
7 6
0: One-shot operaton s not carred out.
: One-shot operaton s carred out.
(caution) 1. Be sure to turn oFF the power before
connecting the connector.
2. For the use of the material end sen-
sor, refer to the Instruction Manual
attached to the material end sensor.
JUKI genune part number
– 49 –
"#-13. removing
p.46.
1
1
5
0
Connector HK04230040
Pn contact HK042340000