JUKI DDL-8700A-7 Instruction Manual page 45

@ 7 Initial motion uP stop position move function (Function setting No. 90)
Effectve/neffectve of automatc return to UP stop poston mmedately after turnng ON the power can be set.
9 0
@8 Function added to the needle up / down compensating switch (Function setting No. 93)
One sttch operaton can be performed only when the needle up / down compensatng swtch s pressed at the tme of
upper stop mmedately after turnng ON the power swtch or upper stop mmedately after thread trmmng.
9 3
@9 continuous stitching + one shot stitching nonstop function (Function setting No. 94)
Ths functon s used to proceed a step to the next one wthout stoppng the sewng machne at the end of the
step when performng sewng wth the contnuous sewng and one-shot sewng combned usng the program-
mng functon of the operaton panel IT.
9 4
#0 Setting of max. number of rotation of the sewing machine head (Function setting No. 96)
Ths functon can set the max. number of rotaton of the sewng machne head you desre to use.
Upper lmt of the set value vares n accordance wth the sewng machne head to be connected.
9 6 4 0
#1 LED light dimmer utility setting (Function setting No. 109)
Used to adjust brghtness of the LED lght
1 0 9 1
#2 Main shaft reference angle compensation (Function setting No. 120)
Man shaft reference angle s compensated
1 2 0 –
#3 uP position starting angle compensation (Function setting No. 121)
Angle to detect UP poston startng s compensated.
1 2 1
#4 DoWN position starting angle compensation (Function setting No. 122)
Angle to detect DOWN poston startng s compensated.
1 2 2
#5 Setting of energy saving function during standby (Function setting No. 124)
It s possble to reduce power consumpton whle the sewng machne s n standby state. It should be noted
that the startup of the sewng machne may delay for a moment f ths functon s set.
1 2 4
0 : Ineffectve
1
 : Effectve
0 : Normal (Only needle up / down compensatng sttchng operaton)
0
 : One sttch compensatng sttchng operaton (upper stop / upper stop)
s performed only when aforementoned changeover s made.
0 : Normal (Stop when a step has completed.)
0
 : The sewng machne proceeds to next step wthout stoppng after a
step has completed.
50 to Max. [st/mn] <50 / st/mn>
0 0
Settng range
0 0
0 to 00
Settng range
2 3
– 60 to 60˚ <1 / ˚>
Settng range
5
– 15 to 15˚ <1 / ˚>
Settng range
0
– 15 to 15˚ <1 / ˚>
0 : Energy-savng mode s neffectve.
0
 : Energy-savng mode s effectve.
– 42 –