6. adjusting the height of the knee lifter
WarNING :
Be sure to turn the power oFF before the following work in order to prevent personal injury due to
unintentional starting of the sewing machine.
)
The standard heght of the presser foot lfted usng the knee lfter s 0 mm.
2)
You can adjust the presser foot lft up to 3 mm usng knee lfter adjust screw 1 .
3)
When you have adjusted the presser foot lft to over 0 mm, be sure that the bottom end of needle bar
2 n ts lowest poston does not ht presser foot 3 .
7. Installing the thread stand
2
1
1
– 8 –
3
)
Assemble the thread stand unt, and nsert t n
the hole n the machne table.
2)
Tghten nut 1 .
3)
For celng wrng, pass the power cord through
spool rest rod 2 .
2